Products

A POS rod end can form one end of an adjustable link. Its external thread enters the mating rod or block, and a locknut holds the required bearing-center position.

This stud-mounted cam follower includes a side lubrication opening in the mounting shaft. The port remains accessible after installation when its position is considered during the machine layout.

HGWS60K is an open linear table with its ball screw positioned above the guide base. The exposed arrangement provides direct access to the screw, nut connection and motor coupling.

DB and DS brackets create a rigid bridge between a motor flange and a ball screw drive end. Their open sides leave the shaft coupling accessible after the motor has been installed.

The GM coupling is machined as one aluminum piece, with spiral slots separating the two shaft hubs. Standard outside diameters range from 12 mm to 50 mm.

FK and FF support numbers do not always form an equal-number pair. The correct combination is determined by the two machined shaft ends and the mounting geometry of the machine endplates.

SK16 holds the end of a 16 mm round shaft above the machine plate. Its split aluminum body closes around the shaft when the side clamp screw is tightened.

POSA15 is a rod-end joint with an external threaded shank. It connects a linkage rod to a pivot pin while permitting limited angular movement at the eye.

A round motion rod supplied in lengths from 100 mm to 2950 mm, with a ground and polished outside surface specified to g6 tolerance.

The EGH guide places the carriage mounting surface close to the rail, helping reduce the total height of a machine slide without changing to a miniature guide system.

SFK is a short-bodied flanged ball screw family covering shaft diameters from 4 mm to 25 mm. The series is useful when the nut must fit inside a narrow carriage, but its flange and body dimensions

Two polished round shafts carry the black saddle of the GZS90K, while a ball screw runs through the centre of the frame. The shafts control the travel path; the screw supplies the pushing and pulling