Products

A supported round-shaft guide fitted with a flanged TBR bearing block, available in 16 mm, 20 mm, 25 mm and 30 mm shaft sizes.

The GFC coupling joins two rotating shafts through a pair of aluminium jaw hubs and a replaceable polyurethane spider.

A stud-mounted track roller filled with uncaged needle rollers, intended for mechanisms where radial load takes priority over maximum rotational speed.

A solid round shaft prepared as the contact track for recirculating linear bearings, with diameters available from 3 mm through 150 mm.

The GZS90K is a single-axis positioning unit with a ball screw drive, linear guide and separately accessible motor coupling.

An SFS ball screw assembly with a DIN 69051 Form B nut, intended for CNC machinery and other equipment requiring efficient conversion between rotary and linear movement.

The BC15Z combines a motor mounting flange and a BK15 fixed end support in one housing, keeping the motor and ball screw on a common connection axis.

This BC series bracket brings the motor mounting face and ball screw fixed-end seat into one structure. It is used to keep the motor shaft, coupling and screw end on a shared centerline.

HGHP140F is a timing-belt linear stage developed for long travel and rapid positioning. A single module provides one controlled axis; two units may be mounted at right angles when an XY arrangement

A cam roller carries motion directly against a shaped cam or straight running track. Unlike a conventional bearing installed inside a housing, its outer ring becomes the wheel that contacts the

LMF8UU combines an 8 mm linear bushing with a circular mounting flange. The flange allows the bearing to be fastened directly to a moving plate without adding a separate bearing housing.

A 25 mm ball screw with a 5 mm lead and a DFU double-nut assembly. It is intended for mechanisms where direction changes must produce controlled linear travel with limited lost motion.