Products

The LMK series combines a short linear ball bushing with a square four-hole flange, allowing a moving plate to be connected directly to a round-shaft guidance system.

The LM LUU series is an extended cylindrical ball bushing for round-shaft guidance. Its longer body separates the shaft contact zones across a greater distance than a standard LM UU bearing.

The SHF holder fixes a round linear shaft against a flat mounting face. Two flange holes secure the body, while a separate clamp screw closes the split bore around the shaft.

HGH15CA is a square carriage for an HGR15 profiled rail. Its threaded holes face upward, allowing a moving plate or fixture to be fastened directly onto the top of the block.

This track roller combines its mounting stud, rolling element and clamping thread in one unit. A lubrication passage opens at the end of the stud so grease can be renewed after installation

FK6 and FF6 form a compact end-support pair for a small ball screw. Their flanged bodies attach against machined end plates instead of sitting on top of the machine base.

A female-thread rod end with a spherical inner ring and an external grease point. The page identifies carbon steel as the product material despite the stainless-steel wording in the original URL.

LM25UU is a 25 mm closed linear bearing measuring 40 mm across the outer cylinder and 59 mm in length. It fits inside a separate housing and travels on a hardened round shaft.

BK and BF units establish two different support conditions for a ball screw. BK fixes the drive-side shaft position, while BF steadies the opposite journal without duplicating the fixed-end

The HGW carriage uses a broad mounting flange to connect machine tables and fixtures to an HGR profiled rail. Its wider bolt footprint is the main structural difference from the narrower HGH block.

This solid linear shaft has an induction-hardened, ground and polished outside diameter. The finished surface is the running race for the balls and seals inside a round linear bearing.

KR30 is a caged stud-type cam follower with a 30 mm outer-ring diameter and a 12 mm stud seating diameter. The roller-side hex socket allows the stud to be held while its mounting nut is tightened.