Linear Shaft

A solid linear shaft machined to your diameter, length, and finish — sized from 3mm up to 150mm, with drilling, threading, and hole-tapping done to spec rather than sold only in fixed stock

This hollow shaft provides a continuous ground running surface while removing material from the center. It is intended for assemblies that require a smooth bearing track but do not need the mass of a

A stainless steel shaft designed as the running surface for linear motion components. It provides a corrosion-resistant alternative for mechanisms where a standard carbon-steel shaft may not suit the

This solid linear shaft has an induction-hardened, ground and polished outside diameter. The finished surface is the running race for the balls and seals inside a round linear bearing.

This solid GCr15 shaft has a hard-chrome working surface for contact with linear ball bearings and sliding bushings. Core material and surface coating are separate specifications and should both be

A round motion rod supplied in lengths from 100 mm to 2950 mm, with a ground and polished outside surface specified to g6 tolerance.

The SP series provides a hardened external bearing track around a central bore, reducing shaft mass while leaving an internal passage available for the machine design.

A solid round shaft prepared as the contact track for recirculating linear bearings, with diameters available from 3 mm through 150 mm.

A solid round shaft ground for use with matching linear bearings in guided machine movement. Diameter, material and end machining can be selected around the bearing and mounting arrangement.

A solid round shaft provides the running surface for a linear bushing. This series is supplied in diameters from 3 mm to 150 mm, with standard GCr15 shafts hardened, ground and finished for linear

The GY-EGHP210F Belt Driven Linear Module combines a 50 mm-wide synchronous belt with two EGR20 guide rails for horizontal transfer. Its catalogue stroke range is 100–3,750 mm, with a maximum listed

The 25mm Shaft for Linear Bearings provides a hardened cylindrical running surface for round linear ball bearings. The catalogue specifies GCr15 steel, HRC62±2 hardness and a g6 diameter tolerance,