Rod End Bearing

SI16 connects a 16 mm pivot pin to an M16 threaded control rod. Its female housing allows the installed linkage length to be adjusted without adding a separate threaded sleeve.

A female-thread rod end with a spherical inner ring and an external grease point. The page identifies carbon steel as the product material despite the stainless-steel wording in the original URL.

KR30 is a caged stud-type cam follower with a 30 mm outer-ring diameter and a 12 mm stud seating diameter. The roller-side hex socket allows the stud to be held while its mounting nut is tightened.

This page brings together SI, SA, PHS and POS rod ends for linkage construction. The four series provide a choice between internal and external threads while retaining a spherical eye at the

A POS rod end can form one end of an adjustable link. Its external thread enters the mating rod or block, and a locknut holds the required bearing-center position.

POSA15 is a rod-end joint with an external threaded shank. It connects a linkage rod to a pivot pin while permitting limited angular movement at the eye.

The SA rod end screws into the end of a linkage through its external threaded shank. A bolt or pin passes through the spherical inner ring, allowing the connected parts to change angle without

The POS series combines an external threaded shank with an articulated spherical bearing. It is designed for adjustable mechanical linkages that require angular movement and periodic grease

A male-thread spherical rod end for linkage assemblies that require angular movement, oscillation and compensation for limited mounting misalignment.

The SA E series places a spherical bearing eye on an externally threaded shank. Its broad size range suits linkage connections that must carry load while following slow changes in angle caused by

SI T/K rod ends provide a threaded socket and a pivoting bearing eye in one component. The internal thread connects to a male-threaded linkage, while the spherical joint accommodates the changing

This SA series covers externally threaded spherical rod ends from SA5T/K through SA35T/K. The joint connects directly to a female-threaded linkage while allowing controlled angular displacement