Products

The photographs show an FK fixed-end unit and an FF support-end unit supplied as one ball screw mounting pair. Their similar four-hole housings perform different jobs and connect to differently

The LMH unit places a linear ball bearing inside a cylindrical body with an oval four-hole flange. It is installed through a prepared plate so the bearing body sits behind the mounting face rather

This page brings together SI, SA, PHS and POS rod ends for linkage construction. The four series provide a choice between internal and external threads while retaining a spherical eye at the

This SFU assembly consists of a threaded screw shaft and a matching flanged ball nut. The page lists standard designations from SFU1204 to SFU5020, with shaft length and end machining prepared for

The GY-SBRS140K is a 140 mm series linear stage with an exposed ball screw, two round guide shafts and a wide drilled carriage. Its open construction keeps the transmission components accessible for

The product shown is an MGN15H miniature guide assembly. Its H-type carriage provides a longer mounting body than the standard short-block version, while the 15-series rail keeps the complete

The SCS unit provides a ready-made carriage for a round shaft. Its completely enclosed bore surrounds the shaft, while the flat aluminum body gives the machine builder a direct surface for attaching

The KR track roller combines a caged needle-roller assembly, an integral mounting stud and an internal hexagonal drive. It is designed for installation through a machine plate where the outer ring

The GFC series connects motor and driven shafts through two aluminum clamp hubs and a polyurethane spider. Its separable three-piece construction allows the flexible element to be inspected or

This GZS90K page covers the mechanical axis and the information needed to connect it to a stepper or servo drive. Motor, sensor and controller supply must be defined in the quotation.

An aluminum pedestal with four base holes and a vertically split shaft bore. Two side screws close the upper section around a stationary round shaft.

SFE1616 combines a 16 mm screw diameter with a 16 mm lead. One shaft revolution therefore produces 16 mm of nominal nut travel.