Linear Stage

GZS90K is a ball screw linear axis prepared for 400 W or 750 W motor configurations. Its separate coupling section connects the selected motor to the screw while keeping the drive components

The EGW combines a low mounting height with a carriage wider than its rail. This arrangement provides a broad connection area for compact tables, fixtures and stacked motion assemblies.

EGWP95F-I is a long-travel belt axis with six available motor positions. Its 25 mm synchronous belt provides a nominal 50 mm feed per drive revolution, with published speeds up to 2000 mm/s.

EGWP95F-I is supplied in multiple body lengths rather than as one standard module with an altered travel stop. Each effective stroke corresponds to a specified guide length and module weight,

EGHP175F is a long-stroke linear axis that pairs a 50 mm timing belt with two EGR20 guide rails and four EGH20 blocks. The published configuration provides strokes up to 3750 mm for horizontally

The EGHS95F II uses two profile rails to support the moving table on both sides of its ball screw. This layout is intended for installations where tooling weight or working force may not act directly

HGHS210F is an open-top linear stage with a central ball screw, two parallel profile rails and a wide carriage plate. Published working strokes extend from 100 mm to 1600 mm.

The GY-SBRS140K is a 140 mm series linear stage with an exposed ball screw, two round guide shafts and a wide drilled carriage. Its open construction keeps the transmission components accessible for

This GZS90K page covers the mechanical axis and the information needed to connect it to a stepper or servo drive. Motor, sensor and controller supply must be defined in the quotation.

HGWS60K is an open linear table with its ball screw positioned above the guide base. The exposed arrangement provides direct access to the screw, nut connection and motor coupling.

Two polished round shafts carry the black saddle of the GZS90K, while a ball screw runs through the centre of the frame. The shafts control the travel path; the screw supplies the pushing and pulling

An open-frame positioning table with direct access to the ball screw, nut housing and end supports for inspection, lubrication and mechanical adjustment.