Shaft Support

The SHF secures a stationary linear shaft where the shaft axis meets a mounting plate at a right angle. Its two-hole flange fixes the support to the plate, while the divided bore closes around the

An aluminum pedestal with four base holes and a vertically split shaft bore. Two side screws close the upper section around a stationary round shaft.

SK16 holds the end of a 16 mm round shaft above the machine plate. Its split aluminum body closes around the shaft when the side clamp screw is tightened.

The SHF holds the end of a round guide shaft against a vertical machine plate. Two flange holes secure the support to the plate, while a separate split-bore clamp grips the shaft.

The SHF-A secures the end of a round guide shaft to a machine frame through a split bore and a two-hole mounting flange. Available models cover shaft diameters from 3 mm to 60 mm.

The SK series is a compact pedestal used to hold a round rod above a machine base. A cut through the bore allows the grip to be released and retightened during assembly.

The SK series holds a round linear shaft above a flat mounting surface. Its aluminum body combines a raised shaft bore, two base-mounting holes and a split clamp for locking the shaft in position.

A flange-mounted aluminum holder for securing the end of a round linear shaft. The split bore closes around the shaft when the clamp screw is tightened, allowing installation without a press fit.

Set the shaft in position first, then tighten the clamp. That's the whole idea behind this support's split-flange design: instead of pressing a fixed bore against the shaft during assembly, the

A pillow block support that clamps, aligns, and rigidly holds a round linear shaft in place — the stationary anchor point that keeps a hard-chrome-plated or stainless steel shaft straight and stable

A vertical support bracket that clamps a linear shaft in place and keeps it parallel and stable during motion — the SK series specifically covers the vertical-mount configuration, as opposed to a

A two-bolt aluminum shaft support that clamps the end of a matching round linear shaft and helps prevent axial or rotational movement.