Products

The HGH set combines a tall square carriage with a matching profiled rail. The carriage is fastened to the moving table through four threaded top holes, while the rail is secured directly to the

The SFY is a ground ball screw with an end-cap return nut and a lead designed for rapid linear travel. Available combinations extend from 16 mm diameter with 16 mm lead to 50 mm diameter with 100 mm

The DFU combines two matched ball nuts on one screw shaft to improve axial rigidity and reduce lost motion when the travel direction reverses.

EGWP95F-I is a long-travel belt axis with six available motor positions. Its 25 mm synchronous belt provides a nominal 50 mm feed per drive revolution, with published speeds up to 2000 mm/s.

The GL series uses two stainless-steel diaphragm sections and split clamp hubs to connect motor and driven shafts without a keyway or elastomer insert.

LMK10UU combines a 10 mm linear ball bushing with a square mounting flange. The flange attaches to the moving plate, while the cylindrical section passes into a clearance opening behind it.

The SK series positions a round guide shaft above the machine base using an upright body, a split clamping bore and a two-point mounting foot.

This rolled ball screw is fitted with a DFU-style double nut to control axial clearance before the assembly enters service. It is intended for feed systems where direction changes must occur without

PHS10 is a greaseable female-thread rod end built around a 10 mm spherical bore and an M10 × 1.5 internal connection. A bronze liner separates the hardened inner ring from the housing, while the side

The EGW series uses a wide flange carriage and four 45-degree ball-contact zones to support forces arriving from different directions. The page covers multiple sizes from EGW15 through EGW35 rather

EGWP95F-I is supplied in multiple body lengths rather than as one standard module with an altered travel stop. Each effective stroke corresponds to a specified guide length and module weight,

A stainless steel shaft designed as the running surface for linear motion components. It provides a corrosion-resistant alternative for mechanisms where a standard carbon-steel shaft may not suit the