Products

DB and DS brackets create a fixed housing between a motor and a ball screw drive. The open-sided body leaves room for the shaft coupling while the two end plates establish the motor and bearing

KR19 combines a 19 mm track roller with an M8 × 1.25 threaded stud. Instead of fitting the bearing onto a separate shaft, the stud becomes the mounting point for a cam mechanism, guide track or

The GFC coupling places a polyurethane spider between two aluminum hubs. Motor torque passes from one hub into the spider and then into the opposite hub, adding a replaceable cushioning element to

The GIC series uses parallel machined slots to create a flexible section between two clamp hubs. It is designed for compact motor and encoder connections where torque must pass through without a

The GC series uses an aluminum body with a grooved flexible center and clamping ends. It joins two rotating shafts while allowing the coupling body to absorb small installation deviations.

The GM coupling is machined from one piece of aluminum alloy, with a spiral cut through its center section. This cut allows the body to flex slightly when two connected shafts are not perfectly

The GL series links a servo motor to a driven shaft through two stainless steel diaphragm packs. The double-diaphragm layout accommodates limited mounting offset while maintaining direct

Made for a 20 mm round shaft, the SC20UU arrives as one assembled carriage rather than a loose bushing and housing. Bolt the aluminum block to the moving plate, align it with the shaft, and the

LMEK bearings combine a closed linear bushing with a square mounting flange. The four-hole flange lets the bearing bolt directly to a moving plate, eliminating the need for a separate pillow block.

LM12UU provides recirculating-ball guidance for a 12 mm round shaft within a 21 mm diameter and 30 mm long cylindrical envelope. Its standard-length body is suited to compact carriages where a

LME16UU is a standard-length cylindrical ball bushing sized for a 16 mm linear shaft. Its European-series dimensions—26 mm outer diameter and 36 mm overall length—allow it to be installed inside a

LM08LUU is an extended linear ball bushing for an 8 mm round shaft. Its 45 mm body contains four recirculating ball circuits, providing a longer internal contact arrangement than the standard-length