China Linear Guide Rail CNC Manufacturers Factory Suppliers

TBR linear rail system has two mounting methods, up-mounting or down-mounting. And its assembly height is less than SBR linear rail, so it will be available for compact space.

The SBR16 is a ready-matched linear guide consisting of a 16 mm round shaft, an aluminum support profile and an open-type recirculating-ball carriage. Continuous support beneath the shaft allows the

SCE and SCEL units place a recirculating ball bushing inside a machined aluminum housing, creating a carriage that can be fastened directly to a moving plate and guided by a round shaft.

A supported round-shaft guide fitted with a flanged TBR bearing block, available in 16 mm, 20 mm, 25 mm and 30 mm shaft sizes.

The TBR system carries a hardened round shaft on a continuous aluminum base. Its wider rail profile and matching TBR carriage form a complete supported-shaft guide for linear travel.

CNC worktables and tool holders put a slide through thousands of direction reversals a day, and the flanged slider on this TBR-based system is built specifically to hold up under that kind of

TBR guide rails use a flanged slider with through-threaded mounting holes and a solid base, trading the SBR rail's lighter hollow-aluminum construction for higher rigidity and load capacity.

The SCAJ block carries a round shaft in an aluminium housing and allows the bearing clearance to be adjusted during installation.

TBR16 is a 16 mm round shaft fixed along an aluminium support rail. Its lower mounting height makes it useful where an SBR rail would sit too high.

A short aluminum bearing block made for linear travel on metric round shafts from 8 mm to 60 mm.

Linear Motion Ball Slide is a mechanical device used to support and guide a moving part so that it can carry out reciprocating linear motion in a given direction. It is usually composed of a guide

The features of TBR linear rails are High Precision, High Speed, Long Life, High Reliability, Low Noise, Reduce Friction and Good Quality.