Contact Us
- No.979, Qingchun Street, Liandu District, Lishui, Zhejiang, China
- admin@gyballscrew.com
- +0578-2950898
DFU Long Ball Screw Assembly
DFU double nuts allow preload to control axial clearance during direction changes. For long-axis assemblies, the nut configuration, screw lead and finished shaft length must work together; a 3000 mm shaft does not provide 3000 mm of usable travel.
Description
What happens when the axis reverses
When a feed axis changes direction, clearance between the screw and nut can allow rotation before the table responds. The DFU Long Ball Screw Assembly uses two nut sections that can be preloaded against one another to reduce this axial free movement. This arrangement is relevant to machines that repeatedly approach a position from opposite directions.
Preload also changes the nut's response to axial force. However, the double-nut designation alone does not specify a measured backlash value or positioning accuracy. Those requirements need to be defined for the finished assembly. Removing clearance at the nut cannot correct movement in a loose support bearing or coupling.
The product photograph shows the two cylindrical nut sections and an attachment flange. Their combined length needs space inside the moving saddle, particularly when replacing a shorter single nut.
Lead selection affects the required screw speed
The following selected models are listed on this page. The speed column is calculated for a linear feed of 3 m/min; it is a comparison, not a permissible operating-speed rating.
| Model | Nominal diameter (mm) | Lead (mm/rev) | Screw speed at 3 m/min (rpm) |
|---|---|---|---|
| DFU2505 | 25 | 5 | 600 |
| DFU2510 | 25 | 10 | 300 |
| DFU5010 | 50 | 10 | 300 |
| DFU5020 | 50 | 20 | 150 |
A larger lead achieves the same feed rate at fewer revolutions. On a long DFU Long Ball Screw Assembly, this is useful when reviewing shaft speed, but it also changes the torque needed to generate a given axial force. Lead selection therefore belongs alongside the motor and transmission calculation.
The table also shows why diameter and lead must remain separate specifications. DFU2510 and DFU5010 advance the same nominal distance per revolution, yet their shaft diameters differ substantially. They cannot share the same bearing seats, nut housing or shaft-support design.
For an overall length around 3000 mm, usable travel must leave room for the nut assembly, machined ends and end clearance. The distance between supports and their arrangement also affect the allowable rotational speed. A DFU Long Ball Screw Assembly should consequently be specified with both a finished shaft drawing and the intended operating conditions, rather than overall length alone.
About Us
Guangyuan manufactures ball screws to standard specifications and customer drawings, including shaft length and end machining. For DFU enquiries, provide the diameter, lead, nut requirements and dimensions for the bearing seats, locking threads and coupling section. OEM/ODM enquiries are welcome. The minimum order quantity is 10 nuts or 10 screw shafts, according to the item ordered.





Hot Tags: DFU Long Ball Screw Assembly, ChinaDFU Long Ball Screw Assembly suppliers, manufacturers, factory, Ball Screw, Ball Screw 3000mm, Ball Screw CNC, Ball Screw Transmission, Precision Ball Screw Assemblies, Precision Ground Ball Screws
You Might Also Like
















