+86-578-2950898

Latest Products

  • HGH Series Linear Guide Rail
  • SBR Linear Bearing Block
  • SFI Rolled Thread Ball Screw
  • BF Series Ball Screw Support
  • Custom Machined Guide Shaft
  • LM30UU Dual-Seal Ball Bushing Cartridge

Contact Us

SBRS140K Supported Shaft Linear Table video

SBRS140K Supported Shaft Linear Table

SBRS140K Supported Shaft Linear Table carries its moving plate on four SBR20UU blocks arranged across two supported SBR20 shafts. A central 20 mm C7 ball screw provides the feed, bringing the guidance and transmission together for fixture positioning and material handling.

Description

Four bearing blocks beneath the fixture

The broad table connects the fixture to four bearing blocks rather than a single central guide. Their separation across the two shafts provides support on both sides of the drive screw. When a workpiece or tool extends beyond the table center, its position matters as much as its weight because the offset introduces a moment into the guide arrangement.

 

The SBR20 shafts are supported along the base. This gives the moving load a path through the bearing blocks, shafts and supports into the machine structure, instead of relying on round shafts suspended only at their ends. The central ball screw supplies axial motion while the guides constrain the table's travel.

 

Item SBRS140K specification
Guide arrangement Two supported SBR20 shafts
Bearing blocks Four SBR20UU blocks
Ball screw 20 mm diameter, C7 grade
Published repeat positioning accuracy ±0.03 mm
Dimension A Effective stroke + 210 mm
Construction Open screw and guide arrangement

 

For an SBRS140K Supported Shaft Linear Table used as a feeding axis, the load assessment should include the fixture, workpiece and any force applied during the process. A centered carrier and an overhanging tool of equal mass do not impose the same loading on the blocks.

 

Allow for the table, not just its travel

The published length relationship is straightforward: dimension A equals the selected working stroke plus 210 mm. An 800 mm stroke therefore requires A to be 1,010 mm. The motor and surrounding installation clearance must then be considered separately; 800 mm of travel does not fit within an 800 mm machine bay.

 

The exposed construction leaves the screw, bearing housings and shaft surfaces accessible. On a material feeder, this makes it easier to inspect the running surfaces and reach maintenance points. If chips or abrasive dust fall toward the axis, plan external protection around the actual contamination source.

 

The stated ±0.03 mm figure describes repeat positioning, not absolute accuracy over the entire stroke. For the SBRS140K Supported Shaft Linear Table, C7 identifies the screw grade separately. Keep these two specifications distinct when defining the machine's positioning requirement, particularly when the fixture contacts a workpiece at several locations along the travel.

33

3

About Us

Guangyuan reviews SBRS140K enquiries against the requested travel, screw lead, load direction and motor connection. Drawing-based OEM/ODM supply is available for machine integration. Include the fixture layout and available installation space with the enquiry. The minimum order quantity is 1 unit.

 

product-1536-1024product-1536-1024product-1536-1024product-1536-1024product-1122-1402

Hot Tags: SBRS140K Supported Shaft Linear Table, ChinaSBRS140K Supported Shaft Linear Table suppliers, manufacturers, factory, Belt Drive Linear Stage, CNC Linear Stage, Linear Actuator Guide Rails, Linear Guide Rail, Linear Stage Sliding Table, XY Stage Linear Guide

Send Inquiry

(0/10)

clearall