At present, the demand for linear guide rail is increasing gradually, which is basically used in the machinery industry. I believe that everyone has a good understanding of the use of linear guide rail, but the disassembly of linear guide rail is not known to most people. Today, I will share with you the relevant knowledge in this respect.
1. There are all plastic parts at the end and side of the slider of the linear guide rail. When installing, you can't hammer with hard or sharp tools. When commissioning after installation, don't let anything impact it when speeding. If the plastic parts break, the ball will roll out and the slider will fall off.
2. Before leaving the factory, the linear guide rail will be filled with lubricating oil. If you want to clean it, you must dry it first, and then add lubricating oil. It is strictly forbidden to run the linear guide rail without lubrication.
3. If it is not necessary, don't remove the slider from the linear guide. If it must be removed, you must align the auxiliary linear guide first, and then remove the slider.
4. It is strictly forbidden to disassemble the parts of the linear guide rail at will, which will directly affect the accuracy and flexibility. It is strictly forbidden to install nonconforming balls on the linear guide rail at will, otherwise it will directly damage the linear guide rail.
To sum up, we must remember to be careful when disassembling the linear guide rail. If it is not necessary, it is not recommended to disassemble. If necessary, it will be disassembled by experienced technicians, so as to ensure that the linear guide rail will not be damaged during disassembly.
Whatsapp/wechat:17769815516
Email:admin@gyballscrew.com
gykristyliu@gmail.com
